ok a month or so back I received 3 of the 8m4l boards from another member to expand my systems after encoding all of them, they will not function with the older remote only the new remote, and vice versa, old boards will not communicate with new remote(new remote was encoded for testing the regular remote is computer controlled now) the creates a massive problem, has anyone seen this issue? I did not think there were any differences in the ook boards and remotes to cause this problem? I double checked ALL the encoding and it is correct.
Ok looking at every detail of the boards, I found 1 resistor different. Right above encoding pins 3 and 4 is a resistor (it is labeled R1 and is next to the "VR" printed on the board) the old boards have a resistor value of "204" the newer ones say "824". This is linked to the encoding chip I have a feeling that this plays a part in it, if it does I am screwed, with a show in three weeks I now have 128 less cues. I was all ready to install the boards and do final testing today.